JBL Speaker ARC SUB10 User Manual

ARC SUB10  
Powered  
Subwoofer  
simple  
setup guide  
thank you  
for choosing JBL. For more than 50 years, JBL  
has been involved in every aspect of music and film recording  
and reproduction, from live performances to monitoring the  
recordings you play in your home, car or office.  
Were confident that the JBL Loudspeaker you have chosen will  
provide every note of enjoyment that you expected – and that  
when you think about purchasing additional audio equipment for  
your home, car or office, you will once again choose JBL.  
Please take a moment to complete the enclosed profile card.  
It enables us to keep you posted on our latest advancements,  
and helps us to better understand our customers and to build  
products that meet their needs and expectations.  
JBL Consumer Products  
 
one.  
Placement  
In front corner  
two.  
Hookup  
Line-Level – Stereo  
L
R
+
+
Volume  
Low-Level In  
L
Crossover Frequency  
SPKR  
In  
Power  
R
SPKR  
Out  
Min Max  
50  
150  
ARC SUB10  
Discrete Digital AMPLIFICATION  
JBL CONSUMER PRODUCTS  
NORTHRIDGE, CA Made in Canada  
Serial #:  
CAUTION  
RISK OF ELECTRIC SHOCK  
DO NOT OPEN  
~
To reduce the risk of electric shock, do not  
expose this equipment to rain or moisture.  
120V  
60Hz  
100W  
LR110113  
Receiver/Amplifier  
Subwoofer out  
L
R
Note: Some receivers/  
amplifiers have a single  
Main-speaker output  
(mono) subwoofer output. In  
this case, it is recommended  
that you use a “Y-connector  
(not included) to maximize  
the subwoofers performance.  
Right  
Left  
+
+
+
+
Right  
Left  
Loudspeaker  
Loudspeaker  
 
Speaker-Level – Stereo  
Receiver/Amplifier  
Main-speaker output  
+
+
Left  
Right  
L
R
+
+
Volume  
Low-Level In  
L
Crossover Frequency  
SPKR  
In  
Power  
SPKR  
Out  
R
Min Max  
50  
150  
ARC SUB10  
Discrete Digital AMPLIFICATION  
JBL CONSUMER PRODUCTS  
NORTHRIDGE, CA Made in Canada  
Serial #:  
CAUTION  
RISK OF ELECTRIC SHOCK  
DO NOT OPEN  
~
To reduce the risk of electric shock, do not  
expose this equipment to rain or moisture.  
120V  
60Hz  
100W  
LR110113  
+
+
Left  
Right  
Loudspeaker  
Loudspeaker  
Note: When using the speaker-  
level connections, the built-in  
high-pass filter will also limit  
the low frequencies being sent  
to your satellite speakers. This  
means that your satellites wont  
have to try to reproduce the  
information the subwoofer  
is playing.  
 
three.  
Operation  
Mode  
Off  
Procedure  
LED Status  
Red  
Receiver/ amplifier off  
On  
Receiver/ amplifier on and playing program material  
Green  
Red  
Standby  
Simply turn off your receiver/ amplifier. The subwoofer will  
turn off after approximately five minutes. The subwoofer  
will turn on when your receiver/ amplifier begins playing again.  
Volume  
min  
Volume  
max  
min  
Volume  
max  
Crossover Frequency  
The crossover-frequency knob  
determines the highest fre-  
quency your subwoofer will  
reproduce. It allows a seam-  
less transition from the  
subwoofer to the satellite  
speakers. Experiment with  
this adjustment to find the  
crossover frequency that  
sounds best with your  
speakers.  
When the control is at the  
”50“ position, very few high  
frequencies will be heard.  
This position is best suited  
to large main speakers. For  
most users, the control should  
be set somewhere near the  
mid position. For listeners  
using very small speakers,  
best results will be obtained  
with the control at the ”150“  
position.  
Troubleshooting  
If you used the high-level  
(SPKR) inputs and there is  
no sound from any of the  
speakers, check the  
If there is low bass output,  
check the following:  
If you used the line-level  
inputs and there is no  
sound from the subwoofer,  
check the following:  
Make sure the connections  
to the left and right “Speaker  
Inputs” have the correct  
polarity (+ and –).  
Make sure that the sub-  
woofer is plugged into an  
active electrical outlet.  
Powered subwoofer is  
plugged in.  
following:  
Receiver/ amplifier is on  
and a source is playing.  
Powered subwoofer is  
plugged in.  
Check all wires and con-  
nections between receiver/  
amplifier and subwoofer.  
Make sure all wires are con-  
nected. Make sure none of  
the wires are frayed, cut or  
punctured.  
Receiver/ amplifier is on  
and a source is playing.  
Powered subwoofer is  
plugged in.  
Check all wires and connec-  
tions between receiver/  
amplifier and speakers. Make  
sure all wires are connected.  
Make sure none of the  
speaker wires are frayed,  
cut or punctured.  
Adjust the crossover point.  
Review proper operation of  
your receiver/ amplifier.  
Review proper operation  
of your receiver/ amplifier.  
 
Specifications  
Amplifier Power  
100 watts  
Occasional refinements may  
be made to existing products  
without notice, but will  
always meet or exceed  
original specifications unless  
otherwise stated.  
Driver  
10" polylaminate  
Inputs  
Line- and high-level  
Outputs*  
High-level with  
high-pass filter at 180Hz  
Crossover Frequency  
(continuously variable)  
50Hz – 150Hz  
Frequency Response  
(determined by crossover setting)  
35Hz – 150Hz  
Dimensions (H x W x D)  
11-1/ 2 x 17-1/ 8 x 16-1/ 2 inches  
292 x 435 x 419mm  
Weight  
27 lbs/ 12.3 kg  
*High-level (speaker) outputs  
are active only if high-level inputs  
are used.  
JBL Consumer Products  
250 Crossways Park Drive, Woodbury, NY 11797  
8500 Balboa Boulevard, Northridge, CA 91329  
1-800-336-4JBL (4525) (USA only)  
1998 JBL, Incorporated.  
©
JBL is a registered trademark of JBL, Incorporated.  
Part No. ARCSUB10OM 6/ 98  
A Harman International Company  
 

Intel Video Game Controller Intel Gigabit Ethernet Controllers User Manual
Iqua Headphones BHS 701 User Manual
Jacuzzi Hot Tub N870 User Manual
Jasco Universal Remote RM25001 User Manual
Jensen Car Satellite Radio System SRP2002 User Manual
JVC Digital Camera GR DVF31 User Manual
Karcher Pressure Washer K 290 M User Manual
Kenwood Toaster TTM310 User Manual
KitchenAid Dishwasher W10216167A User Manual
Klipsch Speaker CP T User Manual